SARK V4.0.0 Raspi
Contents
INTRODUCTION
SARK V4.0.0 can be run for test and evaluation purposes on the low-cost Raspberrypi ARM platform. This platform is NOT recommended for use in a production environment (we suggest you consider the SARK200 commercial ARM-based platform if you require a low-cost/low-power SIP PBX) but it's great for learning SARK in a low cost environment. You'll also be surprised at just how fast the SARK4 browser app runs on the little ARM processor.
Raspi Install
Installing your Raspberrypi is easy! Download and unzip a raspberry wheezy image from http://www.raspberrypi.org/downloads Just imagecopy (use dd under linux) the Raspberrypi "Raspbian" image onto a 4Gb (or larger) SD Card on your development box. Under Ubuntu this might look something like this (assuming the sdcard is at /dev/sdb)...
sudo dd bs=1M if=2013-02-09-wheezy-raspbian.img of=/dev/sdb
Now, insert the SDcard into your Raspi, power it up, and log in using ssh, either from a linux machine or using something like putty if you have a windows machine. You'll probably need to scratch your head and do a bit of detective work to figure out which IP address the little Raspi is running at. The default login is uid=pi pwd=raspberry. Now, follow the steps below to install a full function SARK image.
Expand the image to fill the disk
run raspi-config to expand the partition to fill the SD Card
sudo raspi-config reboot
SAIL Install
Set up the sail repo
Once the install is complete, log in to your Raspberry Pi. You can do this with a screen and keyboard if you have them attached to your raspberry, but it is much better to use ssh (use Putty if you are working from a Windows desktop). That way you can copy and paste the commands below so there should be less chance of an error.
From the CLI, run the following commands to download and install the public key from the Sail servers and identify the sail repo to Debian. Best to copy and paste these commands because if you get 'em just a tiny bit wrong it won't be nice.
wget http://sailpbx.com/sail/sail-4.0/debs/sail.gpg.key apt-key add sail.gpg.key echo deb http://sailpbx.com/sail/sail-4.0/debs/repo/ wheezy main >> /etc/apt/sources.list apt-get update
Now you can install sail
apt-get install sail
The install will take a good few minutes depending upon the speed of your internet link. During the install you will be asked to enter a root password for MySQL (make a note of it, you'll need it later). You will also be asked to enter the international dial code (IDD) for your country. For example, if you are in the UK, this would be 44. Let the install run to its conclusion.
Seed the CDR database
Now you can seed the Asterisk MySQL CDR database with the following command (substitute the MySQL root password you gave during the sail installation).
mysql -u root --password={your mysql root password} < /opt/sark/stat/asterisk-stat-v2/cdr-mysql-setup.sql
You're done - reboot it
reboot
your sail app will be at http://your.server.ip.address
- UID - admin
- PWD - sarkadmin
It's a full V4 install so it will do everything big-sark will do (well, it won't run a 1000+ seat call-centre, but you get the idea). The only thing missing on the Raspi release is a timing source so you can't use the Asterisk conference facility.
You can find more information on V4 elsewhere in this wiki.
