SPA3k

From sailpbx
Revision as of 09:55, 17 February 2011 by Adminwiki (talk | contribs) (Cisco Linksys SPA3K setup for SAIL V3)
Jump to: navigation, search

Cisco Linksys SPA3K setup for SAIL V3

Here are some set-up instructions for the SPA3K range of SIP ATA/Gateways. These little gateways can be very confusing if you are unfamiliar with SIP and they have a bewildering array of settings. From SARK's viewpoint, the SPA apperas as 2 devices; an extension and a trunk. Here are screenshots for setting them up.

..First the extension

Spa3k-4.jpg

..and now the trunk. Notice that in the trunk we don't fill anything out except the DiD we want to send calls into and the host(dynamic).

Spa3k-6.jpg



Once the trunk is created, you shoud also, for security reasons, use a password (secret) and you would also fill this out in the spa3k browser. we haven't used on in the example, but we would for a real trunk. Also, make a note of the peername (which in -103 appears on the peer screen and you can change it if you wish).

Spa3k-5.jpg

Now we can fill out tyhe details in the spa3k. Select the Line tab in the spa3k browser. Fill it out as shown below (don't forget the dialplan or your spa3k extension won't be able to dial out.

Spa3k-2.jpg . . . Spa3k-3.jpg

Now select the PSTN line panel and fill out proxy ip (IP of Asterisk), a display name (whatever you like), the userID should be the same as the peername which Asterisk has generated for the trunk. In our example it is peer590. Password should be the same as the secret in the trunk.

The other important field is the dialplan 2 setting. In our example, we've used entered (<:01924514426>S0). The 01924514426 is the DiD which will be used to send calls in from this device (which links back to the original DiD we used to create the SARK trunk entry.

Spa3k-1.jpg

Save your changes and the spa3k should register twice; once as an extension and once as a trunk. It is now ready to use.